Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 13)

Snap Linear Knife Maintenance

13
6.
Removing the upper stationary blade
allows access to the wheel blade.
Remove the wheel blade, bearing, and
spacer. Replace the new parts in same
order as removed and shown.
Note: Be careful not to move the carriage
assembly too much as the wheel blade
will fall off.
7. Re-install the upper stationary blade with
the four flat head screws removed from
step 5.
Be sure the wheel blade is behind the
Stationary Blade and that the stationary
blade is oriented so that the cutter edge is
down.
8. Re-install the deflector bracket and entry
guide.