Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 45)

Snap Linear Knife

45
6. Find the other internal harness (05621138)
and remove the hardware mount kits and
install onto the motherboard entry bracket
from the back.
7. With all hardware removed, install the
connector from the back of the
motherboard entry bracket.
Place one washer onto the standoff, insert
through the hole of both the bracket and
connector. Secure, with another washer,
lock washer and nut.
8. Route harness between the upright frame
and the rear frame.
Install connectors to the corresponding
connectors on the MCB.