Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 37)

Snap Linear Knife Appendix A

37
Removing the Knife Assembly
The Linear Knife has its own feed and will reuse the existing printer nip
assemblies. The standard rotary knife assembly needs to be removed from the
printer. Save this unit to convert back to a standard printer in the future.
1. To remove the knife loosen the two ¼”-20
x ½” cap screws using a 3/16” hex tool.
2. Retain the knife and screws for any future
needs. These are not part of the new knife
accessory.