Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 46)

46

Snap Linear Knife
Installing the Linear Knife
– Mechanical Updates
The Linear Knife is ready to install on the printer. Position the printer where
you want to use the system. Relocating the printer with Linear Knife installed is
not advised as they are too heavy and not stable enough to move without
damage.
Installing the Lower Frame Support for the Linear Knife
1. Remove the upper mount shaft for ease of
installing the Linear Knife. It will be re-
assembled a little later.
Locate the lower frame support and Install
it on the end of the SNAP 700
2. Lift the end of the SNAP 700 and place
the bracket with the two large holes over
the corresponding feet of the SNAP 700.
3. Place the SNAP 700 back onto table.