Avery Dennison SNAP 700 RFID Linear Knife - Manual (Page 21)

Snap Linear Knife Adjustments

21
Web Tracking Adjustment
If the web is tracking through the SNAP 700 printer but is not tracking into the
Knife square, there will be a buckle in the web. The tracking can be adjusted by
rotating the thumb wheel on the Linear Knife located on the inboard side of the
Knife.
Buckle in Rear of Knife
(Needs to be adjusted, cut will not be
square.)
Web tracking straight
(No buckle)
Ready to move to the next step
Buckle in Front of Knife
(Needs to be adjusted, cut will not be
square.)