Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 72)

Supported IPMI Commands
RTM-ATCA-7360 Installation and Use (6806800J08M) 72
4.3.6 Get Handle Switch Command
The Get Handle Switch command reads the state of the hot-swap handle of the IPMC.
Overriding of the handle switch state is allowed only if the IPMC operates in (Manual)
Standalone mode.
4.3.7 Set Handle Switch Command
The Set Handle Switch command sets the state of the hot-swap handle switch in (Manual)
Standalone mode.
Table 4-12 Get Handle Switch Command Description
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00
5 Handle Switch Status
0x00: The handle switch is open.
0x01: The handle switch is closed.
0x02: The handle switch state is read from hardware.
Table 4-13 Set Handle Switch Command Description
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00