Supported ipmi commands, 1 standard ipmi commands, 1 global ipmi commands – Artesyn RTM-ATCA-7360 Installation and Use (June 2014) User Manual
Page 61: 2 system interface commands, Table 4-1, Supported global ipmi commands, Table 4-2, Supported system interface commands, Lists all suppor, Chapter 4
Chapter 4
RTM-ATCA-7360 Installation and Use (6806800J08M)
61
Supported IPMI Commands
4.1
Standard IPMI Commands
The MMC is fully compliant to the Intelligent Platform Management Interface v.1.5. This
section provides information about the supported IPMI commands.
4.1.1
Global IPMI Commands
The MMC supports the following global IPMI commands.
4.1.2
System Interface Commands
The system interface commands are supported by blades providing a system interface.
Table 4-1 Supported Global IPMI Commands
Command
NetFn (Request/Response)
CMD
Comments
Get Device ID
0x06/0x07
0x01
-
Cold Reset
0x06/0x07
0x02
-
Warm Reset
0x06/0x07
0x03
-
Master Write-Read
0x06/0x07
0x52
Only for accessing private I2C
buses.
Table 4-2 Supported System Interface Commands
Command
NetFn (Request/Response)
CMD
Set BMC Global Enables
0x06/0x07
0x2E
Get BMC Global Enables
0x06/0x07
0x2F
Clear Message Flags
0x06/0x07
0x30
Get Message Flags
0x06/0x07
0x31
Get Message
0x06/0x07
0x33
Send Message
0x06/0x07
0x34