Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 65)

Supported IPMI Commands
RTM-ATCA-7360 Installation and Use (6806800J08M) 65
4.3.1 Get Status Command
The Get Status command can be used by the payload software to retrieve the status of the
IPMC.
Get Serial Interface Properties Table 4-8 on page 68 0x2E/0x2F 0x01
Set Serial Interface Properties Table 4-9 on page 69 0x2E/0x2F 0x02
Get Debug Level Table 4-10 on page 70 0x2E/0x2F 0x03
Set Debug Level Table 4-11 on page 71 0x2E/0x2F 0x04
Get Handle Switch Table 4-12 on page 72 0x2E/0x2F 0x07
Set Handle Switch Table 4-13 on page 72 0x2E/0x2F 0x08
Reset IPMC Table 4-14 on page 73 0x2E/0x2F 0x0D
Hang IPMC Table 4-15 on page 74 0x2E/0x2F 0x0E
Table 4-6 Pigeon Point Extension Commands (continued)
Command
NetFn
(Request/Response)
CMD
Table 4-7 Get Status Command Description
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00