Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 64)

Supported IPMI Commands
RTM-ATCA-7360 Installation and Use (6806800J08M) 64
4.3 Pigeon Point Specific Commands
The MMC supports additional IPMI commands that are specific to Pigeon Point. This section
provides detailed descriptions of those extensions:
Get AMC Port State 0x2C/0x2D 0x1A -
Get FRU Control Capabilities 0x2C/0x2D 0x1E -
Get target upgrade capabilities 0x2C/0x2D 0x2E -
Get component properties 0x2C/0x2D 0x2F -
Abort firmware upgrade 0x2C/0x2D 0x30 -
Initiate upgrade action 0x2C/0x2D 0x31 -
Upload firmware block 0x2C/0x2D 0x32 -
Finish firmware upload 0x2C/0x2D 0x33 -
Get upgrade status 0x2C/0x2D 0x34 -
Activate firmware 0x2C/0x2D 0x35 -
Query rollback status 0x2C/0x2D 0x37 -
Initiate manual rollback 0x2C/0x2D 0x38 -
Table 4-5 Supported PICMG 3.0 Commands (continued)
Command
NetFn
(Request/Response)
CMD Comments
The firmware upgrade commands supported by the RTM-ATCA-7360 are implemented
according to the PICMG HPM.1 Revision 1.0 specification.
Table 4-6 Pigeon Point Extension Commands
Command
NetFn
(Request/Response)
CMD
Get Status Table 4-7 on page 65 0x2E/0x2F 0x00