Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 37)

Hardware Preparation and Installation
RTM-ATCA-7360 Installation and Use (6806800J08M) 37
4. Tighten the two thumb screws of the hard disk module.
5. Take all necessary steps in your operating system to make the hard disk operable
(the steps depend on the OS you are using).
2.4 Replacing the Hard Disk Module
In this section you can find information on how to replace the hard disk module.
Replacement procedure
To replace the hard disk, proceed as follows.
1. Make sure a replacement hard disk module is available.
2. Take all necessary steps in your operating system to make the hard disk module
ready for removal (the steps depend on the OS you are using).
If the hot swap feature is not supported on your RTM, you cannot replace the hard disk
module yourself. Please send the RTM to your local support representative to have the hard
disk module replaced.
Damage of Circuits
Electrostatic discharge and incorrect RTM installation and removal can damage circuits or
shorten their life.
Before touching the RTM or electronic components, make sure that you are working in an
ESD-safe environment.