Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 63)

Supported IPMI Commands
RTM-ATCA-7360 Installation and Use (6806800J08M) 63
4.2 PICMG 3.0 Commands
The Artesyn Embedded Technologies MMC is a fully compliant AdvancedTCA intelligent
Platform Management Controller i.e. it supports all required and mandatory AdvancedTCA
commands as defined in the PICMG 3.0 and AMC.0 R2.0 specifications.
Get Sensor Reading 0x04/0x05 0x2D -
Get Sensor Type 0x04/0x05 0x2F -
Set Event Receiver 0x04/0x05 0x00 -
Get Event receiver 0x04/0x05 0x01 -
Platform Event 0x04/0x05 0x02 -
Table 4-4 Supported Sensor Device Commands (continued)
Command
NetFn
(Request/Response) CMD
Comments
Table 4-5 Supported PICMG 3.0 Commands
Command
NetFn
(Request/Response)
CMD Comments
Get PICMG Properties 0x2C/0x2D 0x00 -
Get Address Info 0x2C/0x2D 0x01 -
FRU Control 0x2C/0x2D 0x04 -
Get FRU LED Properties 0x2C/0x2D 0x05 -
Get FRU LED Color Capabilities 0x2C/0x2D 0x06 -
Set FRU LED State 0x2C/0x2D 0x07 -
Get FRU LED State 0x2C/0x2D 0x08 -
Get Device Locator Record ID 0x2C/0x2D 0x0D The Artesyn Embedded
Technologies MMCs
support the standard
PICMG 3.0 and the
extended AMC.0 R2.0
versions of this command.
Set AMC Port State 0x2C/0x2D 0x19 -