Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 53)

Controls, LEDs, and Connectors
RTM-ATCA-7360 Installation and Use (6806800J08M) 53
The meaning of these LEDs is described in the following table.
Figure 3-5 RTM-ATCA-7360-L LEDs
Table 3-1 Face Plate LEDs
LED Description
OOS Out Of Service
Red: This LED is controlled by higher layer software, such as middle ware or
applications.
IS Payload Power Status
Green: The payload power has been enabled by the IPMC. Note that this LED
indicates the payload power status both in the early power state and the
normal blade operation.
OFF: Payload power is disabled
Note: This LED is multicolored (red/green/yellow) and is programmable by
IPMC.
ATN Amber: This LED is controlled by higher layer software, such as middle ware or
applications.
SAS port activity
LEDS 0/1 Shows activity on the respective link
HDD HDD activity LED