3 fru inventory commands, 4 sensor device commands, Table 4-3 – Artesyn RTM-ATCA-7360 Installation and Use (June 2014) User Manual
Page 62: Supported fru inventory commands, Table 4-4, Supported sensor device commands, Supported ipmi commands
Supported IPMI Commands
RTM-ATCA-7360 Installation and Use (6806800J08M)
62
4.1.3
FRU Inventory Commands
4.1.4
Sensor Device Commands
Table 4-3 Supported FRU Inventory Commands
Command
NetFn (Request/Response)
CMD
Get FRU Inventory Area Info
0x0A/0x0B
0x10
Read FRU Data
0x0A/0x0B
0x11
Write FRU Data
0x0A/0x0B
0x12
Table 4-4 Supported Sensor Device Commands
Command
NetFn
(Request/Response) CMD
Comments
Get Device SDR Info
0x04/0x05
0x20
-
Get Device SDR
0x04/0x05
0x21
-
Reserve Device SDR Repository
0x04/0x05
0x22
-
Get Sensor Reading Factors
0x04/0x05
0x23
-
Set Sensor Hysteresis
0x04/0x05
0x24
-
Get Sensor Hysteresis
0x04/0x05
0x25
-
Set Sensor Threshold
0x04/0x05
0x26
Most of the threshold-based
sensors have fixed thresholds.
Before using this command,
check whether threshold
setting is supported by using
the Get Device SDR command.
Get Sensor Threshold
0x04/0x05
0x27
-
Set Sensor Event Enable
0x04/0x05
0x28
-
Get Sensor Event Enable
0x04/0x05
0x29
-
Get Sensor Event Status
0x04/0x05
0x2B
-