Artesyn RTM-ATCA-7360 Installation and Use (June 2014) - Manual (Page 41)

Hardware Preparation and Installation
RTM-ATCA-7360 Installation and Use (6806800J08M) 41
2.5.1 Installing the RTM
Installation Procedure
The following procedure describes the installation of the RTM. It assumes that your system is
powered. If your system is unpowered, you can disregard the blue LED and thus skip the
respective step. In this case it is a purely mechanical installation.
1. Locate the slot the RTM is to be installed into the shelf's rear which must be the
same as that of the front blade.
2. Ensure that the top and the bottom handles of the RTM are in an outward position
by squeezing the lever and the latch together.
3. Insert the RTM into the shelf by placing the top and bottom edges in the card guides
of the slot.
4. Slide the RTM into the slot.
5. Apply equal and steady pressure to the RTM to carefully slide the RTM into the shelf
until you feel resistance. Continue to gently push the RTM until the RTM connectors
engage.