Artesyn NITX-315/NITX-315-ET Installation and Use (August 2014) - Manual (Page 79)

BIOS
NITX-315/NITX-315-ET Installation and Use (6806800L71D) 79
Enhanced C3 Enable or Disable Enhanced C3 State. Default is "Disabled".
Table 5-9 Watchdog Timer Configuration
Field Description
Watchdog Timer Select an optimal settings Watchdog Timer (WDT). Items:
Disabled, Enabled. Default value is "Disabled".
WDT Reset Type Select the wanted reset type when the watchdog timer is
triggered. Items: Cold Reset, Warm Reset. Default is "Warm Reset".
Time-Out (Minutes) Set timer to wait before system reset. The value range is from 1 to
10 minutes, the step is 1 minute. Default value is "5 minutes".
Table 5-10 SDIO Configuration
Field Description
SDIO Access Mode Auto Option: Access SD device in DMA mode if controller supports
it, otherwise in PIO mode. DMA Option: Access SD device in DMA
mode. PIO Option: Access SD device in PIO mode.
Default is Auto.
Table 5-11 USB Configuration
Field Description
USB Devices: List the attached USB Devices
USB Support USB Support Parameters.
Legacy USB Support Enables Legacy USB support. AUTO option disables legacy support
if no USB devices are connected. Disable option will keep USB
devices available only for EFI application. Default is "Enabled".
EHCI Hand-off This is a workaround for OSes without EHCI hand-off support. The
EHCI ownership change should be claimed by EHCI driver. Default
is "Enabled".
Mass Storage Devices: List the attached Mass Storage Devices.
Table 5-8 CPU Configuration (continued) (continued)
Field Description