Artesyn NITX-315/NITX-315-ET Installation and Use (August 2014) - Manual (Page 20)

Introduction
NITX-315/NITX-315-ET Installation and Use (6806800L71D) 20
SATA  One internal SATA connector (7-pin)
 One standard 22 (15power+7signal) pins SATA connector for JEDEC
MOS-297A internal slim lite SDD application
MicroSD Card  One Micro SD card slot
USB  Two Hi-Speed USB 2.0 interfaces to USB 2.0 Type A connectors
accessible in the back-panel I/O region
 Four Hi-Speed USB 2.0 interfaces to two 9-pin dual-USB headers,
one is optionally connecting mini PCI-E slot
 One USB client port on an internal header
Ethernet  Supports 10/100/1000 Ethernet based on Marvell 88E1111
RS232  One full signal(8-wire) COM through RS-232 transceiver to header
 Three UART(2-wire) through RS-232 transceiver to one internal
header
CAN bus  One set of CAN bus on one 4-pin internal header
Video  One single-channel LVDS 20-pin header
 One VGA port derived from the SDVO port
Audio  One HDA codec with one Line-in, one Line-out port
TPM ( LPC )  One TPM header for TPM 1.2 module support
Watchdog  One integrated watchdog with sepectable options from
approximately 1 minute to 10 minutes
Form factor  Nano-ITX , 120 mm X 120 mm form factor
OS  Supports Microsoft Windows XP Professional
 Supports Microsoft Windows 7
 Supports Windows Embedded 7 Standard
 Supports MeeGo Linux
Temperature  0-60 °C
Table 1-1 Key Features of the NITX-315 (continued)
Function Features