Artesyn NITX-315/NITX-315-ET Installation and Use (August 2014) - Manual (Page 21)

Introduction
NITX-315/NITX-315-ET Installation and Use (6806800L71D) 21
Table 1-2 Key Features of the NITX-315-ET
Function Features
Processor  Intel Tunnel Creek processor E640T 1.0GHz
 Single channel memory controller supporting DDR2 800 MT/s
memory down
 Both LVDS up to 1280x768 @ 60Hz and SDVO output up to
1280x1024 @ 85Hz output support
 Four x1 lane PCI Express root ports supporting the PCI Express Base
Specification, Revision 1.0a
 Implements an LPC interface as described in the LPC1.1
specification
 SMBus Host Controller based on Version 1.0 support
 Serial Peripheral Interface
 Integrated WDT
IOH  Intel Topcliff IOH
BIOS Device  One 4MB SPI boot device
Memory  Supports 1GB 32-bit DDR2 800 MHz non-ECC memory down on
NITX-315-ET
eUSB Flash  An optional eUSB flash on one 2x5 header on board
PCI-E  One PCI-E x1 slot
 One Mini PCI-E socket
SATA  One internal SATA connector (7-pin)
 One standard 22 (15power+7signal) pins SATA connector for JEDEC
MOS-297A internal slim lite SDD application
MicroSD Card  One Micro SD card slot
USB  Two Hi-Speed USB 2.0 interfaces to USB 2.0 Type A connectors
accessible in the back-panel I/O region
 Four Hi-Speed USB 2.0 interfaces to two 9-pin dual-USB headers,
one is optionally connecting mini PCI-E slot
 One USB client port on an internal header
Ethernet  Supports 10/100/1000 Ethernet based on Marvell 88E1111
RS232  One full signal(8-wire) COM through RS-232 transceiver to header
 Three UART(2-wire) through RS-232 transceiver to one internal
header