Artesyn ATCA-F120 Installation and Use (August 2014) - Manual (Page 22)

Introduction
ATCA-F120 Installation and Use (6806800D06J) 22
1.4.2 Blade Accessories
As of the printing date of this manual, the following blade accessories were available.
Table 1-4 Available Blade Accessories
Accessory Description
RTM-ATCA-F120C Rear Transition Module (RTM) with copper uplinks. It provides access to:

Four 10 Gigabit Ethernet Fabric Channel uplinks via CX4 connectors
 Four 1 Gigabit Ethernet Base Channel interfaces via RJ-45 connectors
 Two 10 Gigabit Ethernet Base Channel uplinks via CX4 connectors
 Four 1 Gigabit Ethernet Fabric Channel interfaces via RJ-45
connectors
 Two RJ-45 telecom clocking interface connectors for inter-shelf
clocking configurations
The RTM is 6E RoHS compliant.
RTM-ATCA-F120-
OPT The main features of this RTM are:

Four 10 Gigabit Ethernet Fabric Channel uplinks via SFP+ connectors
 Two 10 Gigabit Ethernet Base Channel uplinks via SFP+ connectors
 Four 1 Gigabit Ethernet Base Channel interfaces via SFP connectors
 Two 1 Gigabit Ethernet Fabric Channel interfaces via SFP connectors
 Two RJ-45 telecom clocking interface connectors for inter-shelf
clocking configurations
 One serial RS-232 interface for accessing the base blade
 On-board mezzanine management controller (MMC) compliant to
IPMI 2.0