Artesyn ATCA-F120 Installation and Use (August 2014) - Manual (Page 11)

ATCA-F120 Installation and Use (6806800D06J) 11
About this Manual
Overview of Contents
This manual is divided into the following chapters and appendices.
 Chapter 1, Introduction, on page 17 describes the main features of the ATCA-F120.
 Chapter 2, Hardware Preparation and Installation, on page 23 describes installation
prerequisites including the blade installation itself.
 Chapter 3, Controls, LEDs and Connectors, on page 47 describes external interfaces of the
blade. This includes connectors and LEDs.
 Chapter 4, Functional Description, on page 65 describes in more detail functional blocks of
the blade. This includes a block diagram, description of the main components used and so
on.
 Chapter 5, U-Boot Firmware, on page 87 describes the main features of the on-board boot
firmware U-boot and how to work with it.
 Appendix A, Related Documentation provides links to further ATCA-F120-related
documentation
 Safety Notes on page 109 lists safety notes applicable to the blade
 Sicherheitshinweise on page 115 is the German translation of the previous English safety
notes (this had to be included for legal reasons)
Abbreviations
This document uses the following abbreviations:
Abbreviation Description
ACL Access Control List
ADC Analog-to-Digital Conversion
AMC Advanced Mezzanine Card
BBS Basic Blade Service
BT Block Transfer
CoS Classes of Service
DDR Double Data Rate