ARRIS SBM1000 User Guide - Manual (Page 61)

Configuring the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 53
590631-001-a
5. Click OK when prompted, Are you sure that you want to upgrade the firmware?.
6. Click OK. The Transferring file to the device… message and file transfer progress will display.
7. Click OK when prompted, Firmware upgrade successfully, do you want to reboot?. The Reboot screen
displays.
8. Click Reboot and then click OK to restart your adapter. The reboot status will display.
9. When complete, you can log back in to confirm that the upgrade was successful.
Change the Default MoCA Beacon Power Level
Note : Most users will be able to utilize the SBM1000 adapters without making any changes to
the default out of the box Beacon Power Level configuration.
You have the option to configure a specific MoCA Beacon power level for the coax network
interface. If the MoCA Beacon power level must be reduced, it is highly recommended that the
beacon power level is not configured at a value lower than 7. The same configuration changes
you make to the MoCA Beacon power level on one adapter will also have to be made on each
additional adapter on the network. See
MoCA Setup for more information.
Do the following to change the default MoCA Beacon Power level on your home network:
1. Log in to the SBM1100 or SBM1400 Web Admin Interface.
2. Click MoCA Setup link on the left side menu on the screen.
3. Click Beacon Power Level drop down menu button.