beautypg.com

Figure 17 – room 1: sbm1400 adapter installation – ARRIS SBM1000 User Guide User Manual

Page 29

background image

Installing the MoCA Adapters

SBM1000 SMART Video Adapter Kit • User Guide

21

590631-001-a

Figure 17 – Room 1: SBM1400 Adapter Installation

6. Connect one of the Ethernet cables (included) to one of the Ethernet ports on the SBM1400

and the Ethernet/network port on your Smart TV or other Smart device.
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.

7. Connect one of the power adapters (included) to the Power port on the SBM1400 and plug it

into the electrical wall outlet.

To install the SBM1100 (see Room 2 in Figure 16):
8. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the second room (see

Room 2 in Figure 16).

9. Disconnect the coaxial cable from your residential modem/gateway and connect it to the In

connector on one of the RF splitters (included).

10. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1100 and

to one of the OUT connectors on the RF splitter (included).
Note

: You can use either OUT connector on the RF splitter (included) for this installation.

11. Connect a second coaxial cable (included) to the coaxial connector on the residential

modem/gateway and the other OUT connector on the RF splitter (included).

12. Connect one of the Ethernet cables (included) to one of the LAN Ethernet ports on your

router and the Ethernet port on the SBM1100.

13. Connect one of the power adapters (included) to the Power port on the SBM1100 and plug it

into an electrical wall outlet.
ο The Coax LEDs on both MoCA adapters should turn ON within five minutes to indicate

that a secure coaxial connection was established between the two adapters.

ο If the Coax LED does not turn ON within five minutes, disconnect and then reconnect

the power adapters on the SBM1100 and SBM1400. If the Coax LEDs still fail to turn
ON, see

Troubleshooting Solutions

for more information.

14. Power ON your Smart TV, set-top box, laptop, and any other Ethernet-connected devices.