ARRIS SBM1000 User Guide - Manual (Page 31)

Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 23
590631-001-a
4. Connect one of the coaxial cables (included) to one of the OUT connectors on the RF splitter
and the Coax In connector on the SBM1400 (see Figure 19).
Note
: You can use either OUT connector on the RF splitter (included) for this installation.
5. Connect a second coaxial cable (included) to the other OUT connector on the RF splitter and
the Smart TV or set-top box (see Figure 19).
6. Connect one of the Ethernet cables (included) to one of the Ethernet ports on the SBM1400
and Ethernet/network port on your Smart TV or other Smart device.
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.
Figure 19 – Room 1: SBM1400 Adapter Installation
7. Connect one of the power adapters (included) to the Power port on the SBM1400 and plug it
into the electrical wall outlet.
To install the SBM1100 (see Room 2 in Figure 18):
8. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the second room (see
Room 2 in Figure 18).
9. Disconnect the coaxial cable from your residential modem/gateway and connect it to the In
connector on one of the RF splitters (included).
10. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1100 and
to one of the OUT connectors on the RF splitter (included).
Note
: You can use either OUT connector on the RF splitter (included) for this installation.
11. Connect a second coaxial cable (included) to the coaxial connector on the residential
modem/gateway and the other OUT connector on the RF splitter (included).
12. Connect one of the Ethernet cables (included) to one of the LAN Ethernet ports on your
router and the Ethernet port on the SBM1100.
13. Connect one of the power adapters (included) to the Power port on the SBM1100 and plug it
into an electrical wall outlet.
ο The Coax LEDs on both MoCA adapters should turn ON within five minutes to indicate
that a secure coaxial connection was established between the two adapters.