ARRIS SBM1000 User Guide User Manual

Page 30

Installing the MoCA Adapters

SBM1000 SMART Video Adapter Kit • User Guide

590631-001-a

You can now configure your Smart TV and other Ethernet-enabled devices for Internet access
through their related user interfaces.
See

for more information on setting up the MoCA adapters.

2.2 Installing for AT&T U-verse with AT&T Gateway-Integrated

Modem & Router

Figure 18 – Room 1: AT&T U-verse Installation with Gateway

1. Identify the rooms that you want to add to your home network and make sure there is a

coaxial cable connection in each room.

2. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the first room (see

Room 1 in Figure 18).
Note

: Although the SBM1100 and SBM1400 adapters are interchangeable, the SBM1400 is

typically located where more than one Ethernet connection is required (see Room 1 in Figure
18).

3. Check if the coaxial cable is connected to an RF splitter. If it is not, then disconnect it from

your Smart TV or set-top box and connect it to the IN connector on one of the RF splitters
(included).