Figure 29 – room 1: sbm1400 adapter installation – ARRIS SBM1000 User Guide User Manual
Page 42
Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide
34
590631-001-a
Figure 29 – Room 1: SBM1400 Adapter Installation
To install the SBM1100 (see Room 2 in Figure 28):
6. Disconnect the coaxial cable from your gateway/router and connect it to the IN connector on
one of the RF splitters (included).
7. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1100 and
one of the OUT connectors on the RF splitter.
Note
: You can use either OUT connector on the RF splitter (included) for this installation.
8. Connect a second coaxial cable to the coaxial connector on your gateway/router and the
other OUT connector on the RF splitter (included).
Notes
:
ο You may want to install a MoCA filter (included) between your gateway/router and RF
splitter to ensure maximum cable modem network performance.
ο For Telco/DSL data services, skip steps 6, 7, and 8 of this procedure, See Alternate
Room 2 in Figure 28. Connect one of the coaxial cables (included) to the Coax In
connector on the SBM1100 and the secondary coaxial wall outlet.
9. Connect one of the Ethernet cables (included) to one of the LAN Ethernet ports on your
router and the Ethernet port on the SBM1100.
10. Connect one of the power adapters (included) to the Power port on the SBM1100 and plug
it into an electrical wall outlet.
ο The Coax LEDs on both MoCA adapters should turn ON within five minutes to indicate
that a secure coaxial connection was established between the two adapters.
ο If the Coax LED does not turn ON within five minutes, disconnect and then reconnect
the power adapters on the SBM1100 and SBM1400. If the Coax LEDs still fail to turn
ON, see
11. Power ON your Smart TV, set-top box, laptop, and any other Ethernet-connected devices.
You can now configure your Smart TV and other Ethernet-enabled devices for Internet access
through their related user interfaces.
See