ARRIS SBM1000 User Guide - Manual (Page 36)

Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit • User Guide 28
590631-001-a
4 Dish/EchoStar Installation
Figure 24 – Dish/EchoStar Installation
Important! You must ensure the MoCA coaxial network is completely separate from the
Satellite coaxial network in your home. Otherwise, the Satellite Video may not function.
1. Identify the rooms that you want to add to your home network and make sure there is a
coaxial cable connection in each room.
2. Locate the cable wall outlet (or RF splitter) and electrical wall outlet in the first room (see
Room 1 in Figure 24).
Note
: Although the SBM1100 and SBM1400 adapters are interchangeable, the SBM1400 is
typically located where more than one Ethernet connection is required (see Room 1 in Figure
24).
3. Connect one of the coaxial cables (included) to the Coax In connector on the SBM1400 and
the RF port on the cable wall outlet (see Figure 25).
4. Connect one of the Ethernet cables (included) to one of the Ethernet ports on the SBM1400
and the Ethernet/network port on your Smart TV or other Smart device.
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.
5. Connect one of the power adapters (included) to the Power port on the SBM1400 and plug it
into the electrical wall outlet.
To install the SBM1100 (see Room 2 in Figure 24):
6. Disconnect the coaxial cable from your gateway/router and connect it to the IN connector on
one of the RF splitters (included).