AMETEK XDL Series II - Manual (Page 38)

37
OCP Set output over current protection trip point to Amps
V? Return the set voltage of output . For AUX output =3
– response is V where is in Volts
I? Return the set current limit of output
– response is I where is in Amps
OVP? Return the voltage trip setting for output
– response is VP where is in Volts
OCP? Return the current trip setting for output
– response is IP where is in Amps
VO? Return the output readback voltage for output . For AUX output =3
– response is V where is in Volts
IO? Return the output readback current for output . For AUX output =3
– response is A where is in Amps
RANGE Set the voltage range of output to where has the following
meaning:
XDL 35-5 Models: 0=15V(5A), 1=35V(3A), 2=35V(500mA)
XDL 56-4 Models: 0=25V(4A), 1=56V(2A), 2=56V(500mA)
RANGE? Return the set voltage range of output
– response is R where has the following meaning:
XDL 35-5 Models: 0=15V(5A), 1=35V(3A), 2=35V(500mA)
XDL 56-4 Models: 0=25V(4A), 1=56V(2A), 2=56V(500mA)
DELTAV Set the output voltage step size to Volts. For AUX output =3
DELTAI Set the output current step size to Amps
DELTAV? Return the output voltage step size. For AUX output =3
– response is DELTAV where is in Volts.
DELTAI? Return the output current step size
– response is DELTAI where is in Amps.
INCV Increment the output voltage by the step size set for output .
For AUX output =3
INCVV Increment with verify the output voltage by the step size set for output .
For AUX output =3
DECV Decrement the output voltage by the step size set for output .
For AUX output =3
DECVV Decrement with verify the output voltage by the step size set for output
. For AUX output =3
INCI Increment the output current limit by the step size set for output
DECI Decrement the output current limit by the step size set for output
OP Set output on/off where has the following meaning: 0=OFF, 1=ON
For AUX output =3
OP? Returns output on/off status. For AUX output =3
The response is where 1 = ON, 0 = OFF.
OPALL Simultaneously sets all outputs on/off where has the following meaning:
0=All OFF, 1=ALL ON.
If OPALL sets all outputs ON then any that were already on will remain ON.
If OPALL sets all outputs OFF then any that were already off will remain OFF