beautypg.com

Factory default settings – AMETEK XDL Series II User Manual

Page 23

background image

22

# Code

Function

00

Main Output always off at power-up (factory default)

01

Main Output status at power-up the same as at last power-down

02

Aux Output (T models only) always off at power up (factory default).
Set with control assigned to Output 1.

03

Aux Output (T models only) status at power up the same as at last power down.
Set with control assigned to Output 1.

20

Alarm output 'open' for main Output off, 'closed' for main Output on

21

Alarm output 'closed' when Aux Output is in Current Limit.
Set with control assigned to Output 1; applies to Output 1 alarm only.

22

Alarm output 'closed' when over-temperature trip occurs

23

Alarm output 'closed' when sense trip occurs

24

Alarm output 'closed' when over-current trip occurs

25

Alarm output 'closed' when over-voltage trip occurs

26

Alarm output 'closed' when any trip occurs (factory default)

30

Buzzer off

31

Buzzer on (factory default). A single beep indicates confirmation, a double beep
indicates a wrong entry.

33

Lock/Unlock settings. Note that the AUX output settings are locked with Output1.

40

Jog digit flashes, JOG indicator only flashes when jog is 'hidden'

41

JOG indicator always flashes, except when 'hidden' (factory default)

42

JOG indicator doesn't flash, except when 'hidden' (lazy flash)

91

Loads default calibration parameters. Refer to Service Guide

92

Shows firmware version number in the display

93

Sets these # settings to their factory default

94

Loads Factory Default settings (see below)

98

Clears all the output’s set-up memories. AUX output always cleared with O/P1.
In LINK mode, clears all memories in all modes (O/P1, O/P2, AUX & LINK).

99

Enter calibration mode. Refer to Service Guide.

Factory Default Settings

The ex-factory default settings (which will apply at first power-up) are as follows:

Range:

XDL 35-5: 35V/3A

XDL 56-4: 56V/2A

Voltage:

XDL 35-5: 1.000V

XDL 56-4: 1.000V

Current Limit:

XDL 35-5: 1.000A

XDL 56-4: 1.000A

OVP:

XDL 35-5: 40V

XDL 56-4: 60V

OCP:

XDL 35-5: 5.5A

XDL 56-4: 4.4A

Output:

Output off; local Sense

# Settings:

00

Main Output always off at power-up

02

Aux Output always off at power up (an Output 1 # function only).

26

Alarm output 'closed' when any trip condition occurs

31

Buzzer on

41

JOG indicator always flashes; 'lazy' flash when hidden