AGI Security SYS-HC0851S2 - Manual (Page 63)

54
4 Overview of Navigation and Controls
4.1 Boot up and Shutdown
4.1.1 Boot up
Before the boot up, please make sure:
 The rated input voltage matches the device power on-off button. Please make sure
the power wire connection is OK. Then click the power on-off button.
 Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.
 Connect the device to the monitor and then connect a mouse.
 Connect power cable.
 Click the power button at the front or rear panel and then boot up the device. After
device booted up, the system is in multiple-channel display mode by default.
4.1.2 Shutdown
Note
 Whe
n you see corresponding dialogue box “System is shutting down…” Do not click
power on-off button directly.
 Do not unplug the power cable or click power on-off button to shutdown device
directly when device is running (especially when it is recording.)
There are three ways for you to log out.
a) Main menu (RECOM M ENDED)
From Main Menu->Shutdown, select shutdown from dropdown list.
Click OK button, you can see device shuts down.
b) From power on-off button on the front panel or remote control
Press the power on-off button on the DVR front panel or remote control for more than 3
seconds to shutdown the device.
c) From power on-off button on the rear panel.
4.1.3 Auto Resume after Power Failure
The system can automatically backup video and resume previous wor king statu s after
power failure.
4.1.4 Replace Button Battery
Please make sure to use the same battery model if possible.
We recommend replace battery regularly (such as one-year) to guarantee system time
accuracy.
Note:
Before replacement, please save the system setup, otherwise, you may lose the
data completely!