6 image/relay-out, 1 image, 2 relay output – AGI Security SYS-HC0851S2 User Manual
Page 181: Image/relay-out, Image, Relay output
172
Parameter Function
Light and
wiper
You can turn on or turn off the light/wiper.
Figure 5-11
5.6 Image/Relay-out
Select one monitor channel video and then click Image button in section 8, the interface is
shown as Figure 5-12.
5.6.1 Image
Here you can adjust its brightness, contrast, hue and saturation. (Current channel border
becomes green).
Or you can click Reset button to restore system default setup.
Figure 5-12
5.6.2 Relay output
Here you can enable or disable the alarm signal of the corresponding port. See Figure
You can click this icon to
display or hide the PTZ
control platform.
3D Intelligent Positioning
Key
This manual is related to the following products: