AGI Security SYS-HC0851S2 - Manual (Page 243)

234
 PTZ decoder setup, connection or installation is not correct.
 Cable connection is not correct.
 PTZ setup is not correct.
 PTZ decoder and DVR protocol is not compatible.
 PTZ decoder and DVR address is not compatible.
 When there are several decoders, please add 120 Ohm between the PTZ
decoder A/B cables furthest end to delete the reverberation or impeda nce
matching. Otherwise the PTZ control is not stable.
 The distance is too far.
12. M otion detection function does not work.
There are following possibilities:
 Period setup is not correct.
 Motion detection zone setup is not correct.
 Sensitivity is too low.
 For some versions, there is hardware limit.
13. Can not log in client-end or web.
There are following possibilities:
 For Windows 98 or Windows ME user, please update your system to Windows
2000 sp4. Or you can install client-end software of lower version. Please note
right now, our DVR is not compatible with Windows VISTA control.
 ActiveX control has been disabled.
 No dx8.1 or higher. Please upgrade display card driver.
 Network connection error.
 Network setup error.
 Password or user name is invalid.
 Client-end is not compatible with DVR program.
14. There is only mosaic no video when preview or playback video file remotely.
There are following possibilities:
 Network fluency is not good.
 Client-end resources are limit.
 There is multiple-cast group setup in DVR. This mode can result in mosaic.
Usually we do not recommend this mode.
 There is privacy mask or channel protection setup.
 Current user has no right to monitor.
 DVR local video output quality is not good.
15. Network connection is not stable.
There are following possibilities:
 Network is not stable.
 IP address conflict.