AGI Security SYS-HC0851S2 - Manual (Page 103)

94
It is to view channel, IP address, manufacturer, type, system ver sion, SN, video input,
audio input, and etc. See Figure 4-52.
Figure 4-52
4.10.1.2 Image
For analog channel, the camera interface is shown as in Figure 4-53. For digital
channel, the camera interface is shown as in Figure 4-54.
 Channel: Select a channel from the dropdown list.
 Saturation: It is to adjust monitor window saturation. The value ranges from 0 to 100.
The default value is 50. The larger the number, the strong the color is. This value has
no effect on the general brightness of the whole video. The video color may become
too strong if the value is too high. For the grey part of the video, the distortion may
occur if the white balance is not accurate. Please note the video may not be
attractive if the value is too low. The recommended value ranges from 40 to 60.
 Brightness: It is to adjust monitor window bright. The value ranges from 0 to 100. The
default value is 50. The larger the number is, the bright the video is. When you input
the value here, the br ight section and the dar k section of the video will be adjusted
accordingly. You can use this function when the whole video is too dark or too bright.
Please note the video may become hazy if the value is too high. The recommended
value ranges from 40 to 60.
 Contrast: It is to adjust monitor window contrast. The value ranges from 0 to 100. The
default value is 50. The larger the number is, the higher the co ntrast is. You can use
this function when the whole video bright is OK but the contrast is not proper . Please
note the video may become hazy if the value is too low. If this value is too high, the