AGI Security SYS-HC0851S2 - Manual (Page 164)

155
Figure 4-128
4.10.5.4 PTZ
The pan/tilt/zoom setup includes the following items. Please select channel first. See
Figure 4-129.
 PTZ type: There are two options: local/remote. Please select remote if you are
connecting to the network PT Z.
 Control mode: You can select control mode from the dropdown list. There are two
options: Serial/HDCVI. For HDCVI series product, please select HDCVI. The control
signal is sent to the PT Z via the coaxial cable. For the serial mode, the control signal
is sent to the PT Z via the RS485 por t.
 Protocol: Please select DH-SD1 if the control mode is HDCVI.
 Address: input corresponding PTZ address.
 Baud rate: Select baud rate.
 Data bit: Select data bit.
 Stop bit: Select stop bit.
 Parity: There are three choices: none/odd/even.
After completed all the setups please click save button, system goes back to the previous
menu.