AGI Security SYS-HC0851S2 - Manual (Page 219)

210
HDD full
Here is for you to select working mode when hard disk is full. There
are two options: stop recording or rewrite. If current working HDD is
overwritten or the current HDD is full while the next HDD is no empty,
then system stops recording, If the current HDD is full and then next
HDD is not empty, then system overwrites the previous files.
Pack
duration
Here is for you to specify record duration. The value ranges from 1 to
120 minutes. Default value is 60 minutes.
5.8.5.1.2 Date and time
The date and time interface is shown as in Figure 5-72.
Figure 5-72
Please refer to the following sheet for detailed information.
Parameter Function
Date format Here you can select date format from the dropdown list.
Time
Format
There are two options: 24-H and 12-H.
Time zone
The time zone of the device.
System
time
It is to set system time. It becomes valid after you set.
Sync PC You can click this button to save the system time as your PC current
time.
DST Here you can set day night save time begin time and end time. You
can set according to the date format or according to the week format.
NTP You can check the box to enable NTP function.