WaveWare SPS-5 v9E - Manual (Page 6)

NOTE:
For most Normal Grouping of Pagers, it is “Recommended” to use a “Common” Cap Code within a Group of Pagers.
This way the Pagers within that Group will Receive the Message simultaneously, instead of paging them one at a time
from a List of Pagers, which could take awhile to go thru the entire list.
Predefined Messages
“Predefined Messages” are stored messages used for the following types of functions:
“Predefined Messages” can be up to 60 characters in length and the v9E Encoder can support up to 15 “Predefined
Messages”.
Encoder Settings
The v9E - “Settings” are Split into 2 Areas: “Encoder Settings” and “Advanced Encoder Settings”.
The v9E “Encoder Settings” allows Setup of the Following:
 The
“Protocol” of each RS-232 Serial Com Port - TAP, WaveWare, etc.
 The
“Settings” of the RS-232 Serial Com Port and Ethernet Settings
 The
“Advanced Settings” Button, allows changes to Advanced Options.
The available “Advanced” v9E “Encoder Settings” Options include:
0% to 100% (Global Setting) Note: 66% is Default
10 or 32 (Global Setting) Note: 10 is Default
“On” or “Off” (Global Setting) Note: On is Default
0v or 5v (Global Setting) Factory Set before Shipping
“On” or “Off”
“On” or “Off”
Normal or Inverted
Control: None, Hardware or Software
“On” or “Off”
Defaults Button: Resets encoder to Factory Defaults (Global Setting)
This Completes the “Introduction”
“Warranty and other Information” is Next…