WaveWare SPS-5 v9E - Manual (Page 18)

On the Main Screen of Encoder Setup Program, Click on “Group Paging” to Open the Pager Database.
See Fig. 8
Fig. 8 (Group Paging)…Configuration
Pager Groups Screen: Enter The Group ID and list the pager ID’s you want in that group. The ID’s must be in the Pager
Families, programmed previously. Note: In most cases you would use a “Common” Pager Cap Code in the Pager
themselves instead of using Pager Groups. Using a Common Cap code will page all pagers at the same time; whereas
using a group will page each pager one at a time, which is slow.
Pager Groups would be used primarily when “Timer Active” Mode is needed. When finished, Click
“OK” See Fig. 9
Fig. 9 (Pager Groups Setup) If Group 1 is RED , click on the Box to Activate that Group, it will turn Green .