WaveWare SPS-5 v9E - Manual (Page 3)

Introduction – SPS-5 v 9 E Paging System
Your WaveWare SPS-5 v9E Paging System allows you to Send Paging Messages to one or more Persons via
Pagers, and Devices that incorporate
POCSAG Paging Data Receivers. You can setup Automatic Transmission
of Messages or you can Compose Messages on the fly and Transmit them immediately. The V9E is part of the
V9E of paging systems offered by WaveWare. Following is a comparison chart.
Model Serial
Port
Connections
Ethernet Port
Connections Serial Port
Configuration Web Browser
Configuration
V9 2 0 Y N
V9S 1 0 Y N
V9E 1 2 Y Y
The WaveWare v 9E Paging Encoder can be provided in either a Standalone Form or be bundled with a Radio
Transceiver to become a Complete Paging System.
When you attach your Paging System to a PC or other Host Device, plug in the Provided Power Adapter, and
Install and Activate your Paging Software or use a web browser, you will be ready to make full use of the Paging
System.
The WaveWare v 9E Paging System can have a pager database programmed using the WaveWare v 9 Paging
Encoder Setup Software, using a web browser, or you can immediately use the WaveWare v 9E Paging System
without programming.
Your WaveWare v 9E Paging Encoder, using v9.XXE firmware, has the following capabilities:

Serial Port Controlled Operation via RS-232 Serial Port with “Programmable” Communication
Parameters. Baud rates of 300, 1200, 2400, and 9600, with None, Even, and Odd parities. Default setting is
9600 N81, unless specified differently by Customer Requirements.

Ethernet Port Controlled Operation via up to two “Programmable” Ethernet port connections

Independent Configuration of paging control protocol for the serial port and for each of the two Ethernet
connections that are supported.

Configuration from either Windows based configuration software over a serial port or remotely from a web
browser

2 or 5 watts, 5 watts UHF effective radiated power with approximately 2-3 mile range, depending upon
local terrain and obstructions. (Optional 2 watt model also available)

UHF Band (450-470MHz) Synthesized Transceiver. See the Label on the back of the SPS-5 v9E Paging
System to Identify the Operating Frequency of the Paging System. (Optional VHF Band Available)

Industry Standard POCSAG Paging Protocol Covering the Full Range of Paging Functions, Including:

512, 1200 and 2400 bps RF data rates, auto-switching

Alphanumeric (Text), Numeric and Tone/Vibe Only Paging Message Formats

Multiple Tone and Vibration Patterns

Batch Message Delivery, with up to 240 Characters per Message (500 Characters in WaveWare
Mode)

Support for Multiple Paging Control Protocols , now all available over serial port and/or Ethernet port,
Including:

TAP v1.8 (Variations also known as IXO and PET), a bidirectional protocol that provides the most
robust and secure communications interface for radio paging
“Introduction” Continues on the Next Page