WaveWare SPS-5 v9E - Manual (Page 26)

Fig. 22 (Range Test Function)
Range Test Setup
In this screen you can use the Default “Test” message or type any message in the “Base Message” Field (A) .
See Fig. 23
Fig. 23 (Range Test Setup)
A : Base Message = Use Default Message “Test” or any Custom message you want.
B : Pin = Use the Pager ID you entered in previous screen or type another Pager ID you want to use.
C : Cycle Time = Default is 30 seconds but you may enter a different cycle time.
D : Start / Cancel = When ready click “Start” to begin test. When finished click “Cancel” to end the Range Test.
Lookup ID Function