WaveWare SPS-5 v9E - Manual (Page 44)

Example 1:
S,1,0 will set the Carrier Detect function to the “Off” status.
Example 2:
S11 will set the Carrier Detect function to the “On” status.
STATUS COMMAND
You may request the paging encoder to respond with its current programmed settings using the Status command.
The Status command is formatted as follows:
S?
Where the S? Requests the paging encoder to respond with the status of its current programmed settings. The
Status Command can be used in supervisory controlled applications to ensure the encoder is still functioning,
without causing unwanted paging transmissions.
This Completes “Status Commands”
This Completes the “WaveWare Interface Specifications”