WaveWare WiPath PDR-3000 User Manual
User instructions for pdtp

User Instructions For PDTP
Programming software for
Paging Data Terminals (PDTs)
Paging Data Receivers (PDRs)
Paging Serial Receivers (PSRs)
Installing the software
PDTP requires a PC running Windows 2000/NT/XP and at least 32MB RAM.
1. Unzip the installer PDTP.zip to a temporary file or open the installer files in
Winzip.
2. Run the installer by double clicking on Setup.exe.
3. Follow the instructions in the installer wizard.
4. Once installed run PDTP by clicking on the shortcut or selecting esp.exe from
the folder in which it is installed.
5. You will be prompted to Enter Set ID . The key will have been provided to
you or may be contained on the CD in a notepad file called PDTP Key.txt.
6. Hit OK.
7. If your key permits access to more than one Template then a selection of
templates will appear in a new window. If your key only allows access to one
template then PDTP will start automatically in that template.
{Note: templates determine the function of the PDT/PDR e.g. Flex or pocsag, PDT or
PDR etc.}
Connecting the PDT/PDR
Required Items:
*1 x Serial Null Modem DB9 female-to-female cable.
*1 x 12v DC Power supply rated at 0.5 amps (or greater) with
2.5mm center positive plug attached.
1. Plug the serial cable into the PC (COM1 is the default port)
2. Open PDTP
3. Select the template appropriate to the PDT/PDR/PSR that you are
programming. Note if you only have a key for one template then PDTP will
open automatically with that template active.