WaveWare SPS-5 v9E - Manual (Page 21)

Fig. 13 (Settings Icon)…Settings
The “Advanced Settings” Button will give you more Options. The “Restore Defaults” Button will “Reset” Both Com
Ports to “Defaults”. Below are the “Encoder Settings” screen for the Dual Com Ports and Protocols. When Finished,
Click
“OK”. See Fig. 14
Fig. 14 (Default Settings) SPS-5 v 9E Settings Screen
Encoder Settings:
A:
Protocol for the 1
st
Com Port
Choices are TAP, PET and TAP, COMP1,
COMP2, WaveWare and Scope.
B:
Settings for the 1
st
Com Port
Choices are Verbose or Non-Verbose and
Baud Rates of 300, 1200, 2400 and 9600
with Connection Settings of N 8 or E 7.
C:
Advanced Encoder Settings Button
Click on this Button to open the “Advanced”
Encoder Settings Screen for more Options.
See next page.
D:
Ethernet Settings
Click on this Button to open the “Ethernet”
Settings Screen.
E:
Restore Defaults
Clicking this Button will Reset BOTH Com
Ports to Default Settings.
To enter the “Advanced Encoder Settings” Screen you must type in the User ID “Maint” (Not Case Sensitive) .
Click “OK”. See Fig. 15