Paging message command, Example 1, Example 2 – WaveWare SPS-5 v9E User Manual
Page 49
PAGING MESSAGE COMMAND
The Scope Protocol Paging Message
command is formatted as follows:
AN1234567DMessage
A Alphanumeric character representing the type of paging message to be transmitted
A = Alphanumeric
N = Numeric
N Alphanumeric character representing the data rate, in bits per second, at which the paging message
is to be transmitted
N = 512 bps
F = 1200 bps
S = 2400 bps
1234567 7 digits representing the pager cap code, including leading zeroes as required
D Alphanumeric character representing the function code value to be delivered with the message
A = One Beep
B = Two Beeps
C = Three Beeps
D = Four Beeps
Example 1:
AN0046180DThis is a test
Will send the message “This is a test” at 512 bps to an alphanumeric pager with Cap Code 0046180.
Note:
The POCSAG alphanumeric character set is the entire ASCII 7 bit character set.
Example 2:
NN0765155B412-3433
Will send the message “412-3433” at 512 bps to a numeric pager with Cap Code 0765155.
Note:
The POCSAG numeric character set allows Hyphen ( - ), space, left bracket ( [ ), and right bracket ( ] ) characters in
addition to the normal numeric character set.