WaveWare SPS-5 v9E - Manual (Page 34)

This Completes the “Tap Checksum Calculations”
Appendix D – TAP Response Codes
Following is a table of response codes supported by the WaveWare v9E Paging Encoder.
Please note that a response typically means the message should be resent by the host, and an response
typically means the message should be abandoned by the host.
Response Code Definition
110 1.8 Paging system supports TAP Specification v1.8
211 Page(s) Sent Successfully Paging message(s) successfully delivered.
This message is accompanied by an
510 Invalid character in pager ID Pager ID field contains illegal characters.
This message is accompanied by an
511 Invalid pager ID - not in database Pager ID was legal and 1 to 4 characters in
length, but didn’t match database lookup.
This message is accompanied by an
512 Temporarily cannot deliver. Queue full.
Try later Paging System input buffer is full. This
message is accompanied by an
514 Checksum Error. Exp XXX; Got: YYY Checksum didn’t match message block. This
message is accompanied by a
Note: , , and are only representations of the lower order ASCII control characters output by the
paging system.
represents Hex 06, represents Hex 15, and represents Hex 1E.
This Completes the “Tap Response Codes”