KBC Networks WES2HT - Manual (Page 28)

WES2HT User Manual
Manual-WES2HT-Rev1407-1
Copyright © KBC Networks 2013 Page 27 of 142 www.kbcnetworks.com
7. LED Status
7.1 LED Description
1
Signal Strength Indicator – 40 RSSI
2 Signal Strength Indicator – 30 RSSI
3 Signal Strength Indicator – 20 RSSI
4 Signal Strength Indicator – 10 RSSI
5 Not used
6 Ethernet Link Activity
7 Power
7.1.1 LED Boot Up Process
Upon connection of an Ethernet cable from the PSE to the unit, the Power LED 7
will light.
After 1 second RSSI LEDs 1, 2 & 3 illuminate.
RSSI LEDs 1, 2 & 3 then go off.
After 5 seconds the Ethernet Link Activity LED 6, illuminates.
At the same time the Signal Strength Indicator, LED 1 flashes for approximately 2
seconds.
LEDs 1 & 6 then switch off.
LED 6 comes on again and flashes intermittently showing that a connection is
established.
After approximately 1 – 2 minutes RSSI LEDs 1, 2, 3 & 4 will light depending on
the level of signal strength.