KBC Networks WES2HT - Manual (Page 120)

WES2HT User Manual
Manual-WES2HT-Rev1407-1
Copyright © KBC Networks 2013 Page 119 of 142 www.kbcnetworks.com
11.2.4 Topology
The system mapping capability of the topology page enables end users to view system
configuration and health all on one page. WES2HT topology shows the links between
different Station/Clients and Host/APs. System mapping supports dynamic changes in
the network so as the network changes it learns the new topology and updates this on
the topology webpage.
Along with system mapping, the topology view also displays all node information; this
can be viewed by holding your mouse over a particular node and radio. Node hover over
will display following node information:
Node IP address
Bridge MAC address
Root bridge information
Gateway information
Radio up/down status
Radio Host/Client role
Connected peer information
If any parameter eg. IP address , node name , SSID etc changes then topology reports
updates accordingly.
Note: Only KBC Network nodes are shown on the topology page.
If any node goes down within the network then it is shown in red after 100 seconds
(default). If it then remains down for more than 200 seconds (default) the node entry
will be removed from topology view. When the node is reconnected to the network it will
be added back to the topology.