KBC Networks WES2HT User Manual
Page 133
WES2HT User Manual
Manual-WES2HT-Rev1407-1
Copyright © KBC Networks 2013
Page 132 of 142
www.kbcnetworks.com
Setting the Client frequency:
The Client obtains its frequency from its connected Host/AP. To ensure that a particular
Client connects to a certain Host/AP, the SSID, Country Code and Channel Width settings
need to be the same as the Host/AP unit to which the unit wishes to connect to. On the
Client unit, in the Basic Wireless: Radio 1 menu option, ensure that the Remote AP-Lock
to Client is ticked. Click on
you wish to connect to. This will now be shown in the box next to the
The units will now connect on the designated frequency – this may take a few minutes.
Interference Analyzer: The interference Analyzer facility is located on the Host/AP unit
and can be used to determine whether there are other pieces of equipment in the vicinity
using the same frequencies as the WES2HT units use. By carrying out an interference
analyzer survey, congested channels can be avoided when selecting channels manually.
Note:
Surveys to detect interference should only be conducted when directly connected
to the Host/AP, if connected to the Host/AP via the Client over the wireless link, the link
will be disconnected.
To carry out a frequency site survey select
Analyzer is only found on the Host/AP unit and only available if a channel width of either
20M or 20/40MHz is selected.