Dataman 48Pro - Manual (Page 18)

Note: Pin no. 1 is indicated by a triangle on ISP cable
connector.
Dataman-48Pro ISP cable
Warnings:
• When you use Dataman-48Pro as ISP programmer, do
not insert device into ZIF socket.
• When you program devices into ZIF socket, do not insert
ISP cable to ISP connector.
• Use only attached ISP cable. When you use another ISP
cable (other material, length…), programming may be
unreliable.
• Dataman-48Pro can supply programming voltage (pin 1 of
ISP connector) and target system voltage (pin 5 of ISP
connector) with some limitations (see Technical
specification / ISP connector), but target system should
not supply voltage to the Dataman-48Pro.
• Dataman-48Pro applies programming voltage to the target
device. If the programming voltage is different than
expected, the Dataman-48Pro will abort the operation.
Note: H/L/read Dataman-48Pro driver
C1
R1
H/L/read driver
in programmer
pin of ISP
connector
PU/PD driver
in programmer
R2
Selftest and calibration
If you feel that your programmer does not work properly,
please run the programmer selftest using the Diagnostic POD.
The Diagnostic POD is included with the standard package.
For optimal results, we recommend you run the programmer
selftest and calibration every 6 months. See instructions for
selftest in the Diagnostics menu of PG4UW.
18