Applied Motion SV7-C-CE User Manual
Hardware manual
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- Features
- Block Diagrams
- Getting Started
- Mounting the Drive
- Connecting to the PC using RS-232
- Connecting the Drive to Your PC using Ethernet
- Addresses, Subnets, and Ports
- Option 1: Connect a Drive to Your Local Area Network
- Option 2: Connect a Drive Directly to Your PC
- Option 3: Use Two Network Interface Cards (NICs)
- Connecting to a host using RS-485 option card
- RS-232 to RS-485 2-wire Converter
- Converting USB to RS-485
- Connecting the Power Supply
- Choosing a Power Supply
- Connecting the Motor
- Driving a Brushed Motor:
- Connecting Input Signals
- Connector Pin Diagram
- High Speed Digital Inputs
- Using High Speed Inputs with 12-24 Volt Signals
- Connecting Limit Switches
- Wiring a Mechanical Limit Switch
- Wiring a Limit Sensor
- Analog Inputs
- Connecting a Potentiometer to Analog Input 1
- Connecting a Motion Controller to the Analog Input
- Programmable Outputs
- Wiring Integral Holding Brakes
- Interfacing to a Motion Controller
- Encoder Outputs
- Setting Drive Current Limits
- What is “Peak Current Limit”?
- Reference Materials
- Recommended NEMA Motors
- Additional Motor Information:
- Recommended Metric Motors
- Motor Outlines
- Torque-Speed Curves
- Mechanical Outline
- Technical Specifications
- Mating Connectors and Accessories
- Alarm Codes
- Connector Diagrams