Applied Motion SV7-C-CE - Manual (Page 25)

25
SV7 Hardware Manual 920-0012F
12/18/2014
Driving a Brushed Motor:
1. Connect the encoder so the counts increase when the shaft is turned CW as viewed from the
front.
2. Connect motor leads to A and B, leave C open.
3. The + direction of commanded motion will result in terminal B being positive with respect to
terminal A.
4. Armature inductance should be between .5mH and 15mH for best performance.
5. Use the Motor-Encoder tab in QuickTuner™ to configure the drive for a brushed motor.