Altera Transceiver Signal Integrity Development Kit, Stratix IV GX Edition - Manual (Page 13)

Chapter 2: Board Components 2–3
Board Overview
November 2011 Altera Corporation Transceiver Signal Integrity Development Kit,
Stratix IV GX Edition Reference Manual
J28 JTAG programming header
JTAG programming header for connecting an Altera USB-Blaster
dongle to program the FPGA and MAX II CPLD devices.
J26
MAX II JTAG configuration
jumper Jumper to bypass the MAX II CPLD from the JTAG programming
chain.
J63
JTAG for embedded
USB-Blaster MAX II CPLD
JTAG for embedded USB-Blaster MAX II CPLD device programming.
U32 MAX II CPLD
Altera EPM1270256C3N, MAX II 256-pin CPLD for MAX II+Flash FPP
configuration.
D6 Fan LED
Indicates an FPGA over-temperature condition exists and a fan should
be attached to the FPGA and running.
D16–D18 Configuration status LEDs LEDs to indicate the status of FPP configuration.
J62
Configuration program select
jumper Jumper to select the flash configuration image to load upon power-on
or reset.
J65
Socketed Y3 OSC
enable/disable jumper
Jumper to enable or disable the Y3 OSC.
J66 Y4 OSC enable/disable jumper Jumper to enable or disable the Y4 OSC.
J67 Y5 OSC enable/disable jumper Jumper to enable or disable the Y5 OSC.
D3 Power LED Blue LED indicates board power status.
D7 USB-Blaster LED Green activity status LED for embedded USB-Blaster.
D19–D24
Bank of Ethernet LINK and
Status LEDs
Ethernet Link, Speed, Full Duplex, Transmit and Receive activity LEDs.
J6 VCCA voltage selection jumper This jumper selects the V
CCA
voltage to the FPGA.
J11
VCCH voltage selection
jumper
This jumper selects the V
CCH
voltage to the FPGA.
SW16
Power measurement rotary
switch This switch selects 1 of 6 measured FPGA power rails to display on the
LCD.
SW2
Spread spectrum
configuration DIP switch DIP switch to set the spread spectrum output clock frequency and
down-spread percentages.
J18 Spread spectrum clock trigger Spread spectrum clock source routed to SMA for triggering purposes.
J21 Y3 OSC clock trigger Y3 oscillator clock source routed to SMA for triggering purposes.
J22 Y4 OSC clock trigger Y4 oscillator clock source routed to SMA for triggering purposes.
J23 Y5 OSC clock trigger Y5 oscillator clock source routed to SMA for triggering purposes.
J14, J15
Differential SMA clock input to
FPGA core
SMA for receiving a differential external clock input to the FPGA core.
J19, J20
Differential SMA clock input to
FPGA transceiver SMA for receiving a differential external clock input to the FPGA
transceiver.
J16, J17
Differential SMA clock output
from FPGA core
SMA for sending a differential clock output from the FPGA core.
Clock Circuitry
Y2, U20 50-MHz OSC and clock buffer 50-MHz clock to FPGA and MAX II CPLD.
Y3, U22
Socketed OSC and clock
buffer 5×7-mm oscillator socket for installing alternate oscillator frequencies
to the FPGA transceivers.
Table 2–1. Stratix IV GX Transceiver Signal Integrity Development Board Components (Part 2 of 4) (1)
Board Reference Type Description