Altera DSP Development Kit, Stratix V Edition - Manual (Page 21)

Chapter 2: Board Components 2–13
Configuration, Status, and Setup Elements
July 2012 Altera Corporation DSP Development Kit, Stratix V Edition
Reference Manual
MAX II CPLD EPM570GM100
The MAX II CPLD is dedicated to the on-board USB-Blaster II functionality. The
CPLD connects to the CY7C68013A USB 2.0 PHY device on one side and drives the
JTAG and System Console direct USB signals out the other side through the general
purpose I/O (GPIO) pins.
Table 2–7 lists the I/O signals present on the MAX II CPLD EPM570GM100.
Table 2–7. MAX II CPLD EPM570GM100 On-Board USB-Blaster II I/O Signals
Schematic Signal Name Type Description
SC_RX 1.5-V CMOS output USB system console receive LED
SC_TX 1.5-V CMOS output USB system console transmit LED
JTAG_RX 1.5-V CMOS output USB-Blaster II JTAG receive LED
JTAG_TX 1.5-V CMOS output USB-Blaster II JTAG transmit LED
C_JTAG_TCK 2.5-V CMOS output GPIO for on-board JTAG chain clock
C_JTAG_TMS 2.5-V CMOS output GPIO for on-board JTAG chain mode
C_JTAG_TDI 2.5-V CMOS output GPIO for on-board JTAG chain data in
C_JTAG_TDO 2.5-V CMOS input GPIO for on-board JTAG chain data out
USB_CLK 1.5-V CMOS input USB System Console clock
USB_OEn 1.5-V CMOS input USB System Console FPGA output enable
USB_RESETn 1.5-V CMOS input USB System Console reset
USB_DATA(7:0) 1.5-V CMOS inout (8 bits) USB System Console FIFO data bus
USB_RDn 1.5-V CMOS input USB System Console read from FIFO
USB_WRn 1.5-V CMOS input USB System Console write to FIFO
USB_EMPTY 1.5-V CMOS output USB System Console FIFO empty
USB_FULL 1.5-V CMOS output USB System Console FIFO full
USB_ADDR(1:0) 1.5-V CMOS input/output USB System Console address bus
USB_SCL 1.5-V CMOS input/output USB System Console configuration clock
USB_SDA 1.5-V CMOS input/output USB System Console configuration data
FACTORY_REQUEST 1.5-V CMOS input Send FACTORY command
FACTORY_STATUS 1.5-V CMOS output FACTORY command status
M570_CLOCK 1.5-V CMOS input 25-MHz input clock for FACTORY command